Pre-Wired & Potted BlueGhozt LITE RGB Controller – Plug-and-Play Module

Upgrade your lighting system with a fully pre-wired, professionally potted BlueGhozt LITE RGB Controller Module—built in-house for maximum durability, clean installs, and rock-solid reliability. This is the easiest and most dependable way to run BlueGhozt on headlights, taillights, DRLs, underglow, and more.

Why This Module Is Better

Unlike loose controllers or DIY wiring kits, this module is fully built, pre-wired, fused, terminated, and epoxy-potted so it’s ready to run out of the box. No soldering, no guesswork, no wiring mistakes—just mount it, plug it in, run power, and connect via Bluetooth.

Each module is hand-assembled with automotive-grade materials and sealed with high-strength potting epoxy for waterproofing, vibration protection, and long-term durability.

Features

• Official BlueGhozt LITE RGB Controller (40% dealer discount applied)

• Fully pre-wired harness with 3 integrated connectors

• Inline fuse pre-installed for circuit protection

• 2 battery eyelets + butt connector for clean power/ground hookup

• Epoxy-potted module for IP67-level water resistance

• Built for engine bays, trunk installs, fender liners, and exterior lighting

• Ready to pair with the BlueGhozt app via Bluetooth

• Supports turn signals, brake, reverse, parking lights, animations & presets

• Works with custom headlights, taillights, DRLs, halos, and LED accents

Plug-and-Play Installation

1. Mount module anywhere on the vehicle

2. Connect the built-in harness to your lights

3. Run the power and ground eyelets to the battery

4. Open the BlueGhozt app

5. Pair & begin customizing animations

No soldering, no crimping, no wiring complexity.

Built for Reliability

Each module is hand-potted using premium, vibration-resistant epoxy that protects the board from:

• Moisture

• Heat

• Shock

• Corrosion

• Dust & debris

This dramatically increases lifespan and prevents 99% of the failures normally seen in non-potted controllers.

Perfect For:

• Custom headlight builds

• Tail light RGB retrofits

• LED halos / DRLs / accents

• Show cars & daily drivers

• Shops needing plug-and-play repeatable installs

• Builders wanting the cleanest possible controller setup

Why Shops Love It

This module saves 30–60 minutes of wiring time per car, cuts down on mistakes, and eliminates the most common controller failure points. Perfect for installers who want consistent results and faster workflow.

Bulk pricing available for:

• Local installers

• Dealership accessory departments

• Wrap/RGB/retrofit shops

• Audio & 12V shops

(Contact us for dealer pricing.)